From laminate, parquet and linoleum to PVC, carpeting and tiling, my workdays are spent learning about manufacturing processes, composition, performance, laying techniques and maintenance methods. So, I'm not bragging when I tell you I know all there is to know about every flooring product. I love what I do, and I've been doing it for as long as I can remember. Please note: any holes made in the middle of tile should be done with a diamond hole saw.įlooring is my life. an angle grinder with a diamond cutting disc: the fastest option but you will usually have to finish the job with tile nippers, depending on your desired finish.a jigsaw with a special tile-cutting blade: very easy to handle.a circular saw fitted with a tungsten carbide blade: for thin tiles or just a few cuts.tile nippers: great for making small or circular cuts.If you have to make rounded cuts, you can use: Outdoor tiles tend to have straight edges making them easy to trim. However, if you do need to cut some tiles, you can use a manual or powered tile cutter or saw. You won't usually need to cut a lot of tiles when laying exterior tile. When you're done, remove the tile spacers and clean any adhesive stains using a sponge.Use a rubber mallet to fix your tiles in place evenly.As you work, keep checking to see if your tiles are level.Lay your tiles in your desired pattern making sure to place tile spacers between each tile.It is important to apply adhesive to both the tile and the surface. These notches are designed to ensure you use the right amount of adhesive. Spread the tile adhesive onto the surface using a notched spreader.Alternatively, you can attach a mixing paddle to a drill. It is best to use a mixing paddle but you can also mix by hand (using a lot of elbow grease). The tile adhesive must be mixed properly. Next, prepare the tile adhesive in a bucket by mixing the powder with water to the correct ratio.Start with a dry run by laying the tiles in place to ensure that your layout is correct and to identify any tiles you need to cut. However, your tile adhesive must be suitable for outdoor use. The process is just the same as tiling indoors. Once your surface is ready, you can set about laying your tiles using a special tile adhesive. Finally, leave the surface to dry for 24 hours before you lay the tiles.ĭon't forget to treat the edge of the screed with the waterproofing membrane.Leave to dry for several hours (according to the manufacturer's instructions) before applying a second coat.Spread a first coat of the membrane using a brush designed for this purpose.Mix a waterproofing membrane with water according to the product instructions.This way, your base will last longer and there will be less risk of your tiles lifting from the surface. It is essential to waterproof your new surface using products designed specifically for exterior use. Level the screed as you go using the timbers as your guide (or just your straight edge and spirit level if you haven't set up a screed frame).You can then lay the rest of your floor screed.The two preparations should mix to ensure a good bond. Spread a thin layer of screed directly over the bonding agent.Spread your bonding agent evenly over your surface using a paste brush.If you don't have a cement mixer, you can prepare your screed by hand but be prepared for hard work. The two mixtures must be ready to use at the same time. At the same time, mix your screed in a cement mixer.Prepare the bonding agent by mixing it with the ratio of water as set out by the manufacturer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |